Solution to the conveyor belt skid
1, the tail roller bearing damage does not turn or the upper and lower roller bearing damage does not turn too much. The cause of the damage is that the tail floating too much, not timely maintenance and replacement of damaged or inflexible parts, so that the resistance increases and cause skid.
2. The initial tension of the conveyor belt is too small. The tension of the belt off the drum. This situation generally occurs at the start, the solution is to adjust the tension device, increase the initial tension.
3, the start speed is too fast can also form a skid. It can be started slowly at this time. If the use of mouse cage motor, can be touched twice before starting, can effectively overcome the skid phenomenon.
4, the load of the rubber conveyor belt is too large, beyond the capacity of the motor will also slip. The good side of slipping at this time is that it protects the motor. Otherwise, the motor will burn down for a long time. But it's a skid for operation.
5. The friction between the transmission drum and the conveyor belt is not enough to cause the skid. The reason is mostly water on the conveyor belt or wet environment. The solution is to add some terminal rosin to the drum. But pay attention not to use the hand, and the application of blast equipment blowing into, in order to avoid personal accidents.
